Tape Operation

Search System

For each recording, an invisible index mark is placed on the tape. A program index and information are also included for timer recordings. These marks are used to access or scan recordings.

Index Search

Program End Search

1	INDEX SEARCH

ENTER INDEX NUMBER :1

USING 1- 9 KEYS

FORWARD SEARCH :FF

REVERSE SEARCH :REW

NEXT :SEARCH

EXIT :STOP

Press SEARCH*

to display SEARCH in Stop or Play mode, and then

press NUMBER keys

to select recording number.

•To calculate number, see below.

Press FF/SLOW+ or REW/SLOW- on the remote to start search.

Locates end point of recording for continuity.

Press SEARCH twice
1 to display SEARCH in Stop or Play
mode.

2 PROGRAM END SEARCH	Press FF/SLOW+
2 PROGRAM END SEARCH	on the remote to
	start PROGRAM
SEARCH START : FF	END SEARCH.
EXIT :SEARCH	• To cancel, press
	PLAY or STOP.

Examples of Program End Search.

2	INDEX SEARCH	Play begins at
2		search end.

To search forward or back 1 index,

Fig. 1

Program 1

INDEX

Program 2 or BLANK

the current tape position

Press SEARCH button

FORWARD SEARCH : FF

REVERSE SEARCH : REW

press FF/SLOW+ or REW/SLOW- on the remote while screen left is displayed (10 sec.).

•To cancel, press PLAY or STOP.

End Point

Fig. 2
INDEX	Program 1	BLANK	INDEX	Program 2	BLANK

the current tape position Press SEARCH button

	End Point
FF

To Calculate Index Number

Example 1:

To go to rec. 2 from rec. 4, enter 3 and press REW.

1	2	3	4		5	6	7

Fig. 3
	the current tape position
	Press SEARCH button
INDEX	Program 1	BLANK

End Point

Program 2

If search exceeds a few seconds in BLANK area.

Example 2:

To go to rec. 6 from rec. 2, enter 4 and press FF.

NOTE: indicates start points of each recording.

Upon locating end point,

➛search continues 7 sec. past end point,

➛tape rewinds to 10 sec. before end point,

➛tape plays to end point and stops.

Note

•If Index Search is started very close to an index mark, that index mark may not be counted in the search.