Copying Your Tapes Dubbing | Panasonic PV-D4753S manual

Copying Your Tapes (Dubbing)

VHF/

UHF

VIDEO IN 2 L-AUDIO IN2-R

(Audio/Video In Terminals on the front of DECK are available)

1Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on DECK. To monitor the dubbing, also connect TV as shown.

2Connect “L” and “R” AUDIO OUT terminals on Playing VCR to “L” and “R” AUDIO IN terminals on DECK.

In place of Playing VCR, you can use other equipment, such as a Camcorder. Simply connect the unit’s Audio/Video outputs to DECK.

	Playing (Source) VCR	Recording (Editing) DECK
1 Insert a pre-recorded tape.		Insert a blank tape with record tab.
2		Press INPUT to set DECK Input mode to
2		LINE for Video Input.
		(See “Selecting the Input Mode” below.)

Press PLAY, then PAUSE/STILL		Press REC, then PAUSE/STILL
3 immediately to enter PLAY/PAUSE		immediately to enter REC/PAUSE
mode.		mode.

The operation of steps 4 and 5 must be done on the playing and recording VCRs at the same time.


4		Press PLAY to start dubbing.	Press PAUSE/STILL to start dubbing.
4		Playing VCR starts playback.	DECK starts recording.
5		Press STOP to stop dubbing.	Press STOP to stop dubbing.
	To Monitor Dubbing on TV			Selecting the Input Mode

1Turn TV on and tune to the Recording VCR channel (CH 3 or CH 4).

2If Auto VCR/TV (see p. 32) is set to

“OFF,” press VCR/TV on the remote to be VCR mode.

Method 1: Press INPUT repeatedly.

Channel Number ↔ LINE1 ↔ LINE2

Note • Dubbing tapes protected with Copy Guard will result in poor quality recordings.

•“L1” or “L2” lights up on Multi Function Display (about 4 seconds) when LINE1 or LINE2 is selected.

•LINE1: For rear audio/video connection.

LINE2: For front audio/video connection.

Caution:• Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.

•Please note that some tapes cannot be dubbed on DECK. Also, it is not possible to dub DVD/ Video CD/ CD to VHS tapes using DECK.