Before using
Charging time and recordable time
The times shown in the table below show the times at a temperature of 25 oC (77 oF) and a humidity of 60%. This is just a guide. If the temperature is higher or lower than the specified value, the charging time will become longer.
Supplied battery/ | A | 1 h 40 min | |
B | 1 h 15 min | ||
(7.2 V/640 mAh) | (1 h 10 min) | ||
A | 2 h 25 min | ||
|
| ||
| 2 h 15 min | ||
(7.2 V/1150 mAh) | B | ||
(2 h 5 min) | |||
|
| ||
|
|
| |
| A | 3 h 55 min | |
|
| ||
| 4 h | ||
(7.2 V/2040 mAh) | B | ||
(3 h 45 min) | |||
|
| ||
|
|
| |
A Charging time |
|
|
BMaximum continuous recordable time “1 h 10 min” indicates 1 hour 10 minutes. ≥The battery
estimates. The times indicate the recordable time when the viewfinder is used. The times in parentheses indicate the recordable time when the LCD monitor is used.
≥We recommend the Battery Pack
≥The recordable time will become shorter in the following cases:
≥When you use both the viewfinder and the LCD monitor simultaneously while rotating the LCD monitor frontward to record yourself, 0 Lux MagicPix function, etc.
≥When you use this Camcorder with the LCD monitor lit up by pressing the [POWER LCD] button.
≥The batteries heat up after use or charging. The Camcorder being used will also heat up. This is normal.
≥Along with the reduction of the battery capacity, the display will change: r# s# t# u# v. If the battery discharges, then u(v) will flash.
Inserting/removing a cassette
1Slide the [OPEN/EJECT] lever and open the cassette cover.
OPEN/
EJECT
≥When the cover is fully opened, the cassette holder will come out.
2After the cassette holder is opened, insert/ remove the cassette.
≥When inserting a cassette, orient it as shown in the figure, and then securely insert it as far as it goes.
≥When removing, pull it straight out.
3Push the [PUSH] mark 1 in order to close the cassette holder.
1
PUSH
4Only after the cassette holder is completely housed, close the cassette cover.
≥After using, make sure to rewind the cassette completely, remove it, and put it in a case. Store the case in an upright position.
≥If the indicator of the condensation does not display on the LCD screen and/or EVF and you notice condensation on the lens or the main unit, do not open the cassette cover otherwise condensation may be formed on the heads or the cassette tape.
ªWhen the cassette holder does not
come out
≥Close the cassette cover completely, and then open it again completely.
≥Check if the battery has run down.
17
