Connections/Initial Setup (Ready to Play)
Please make all cable or antenna connections before power on.
Connecting
UNIT (rear view)
For ANT./Cable
Connect the cable from Antenna/Cable to the VHF/UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your cable box to the VHF/UHF terminal on the unit with a RF cable.
VHF/UHF
IN from ANT./CABLE
VHF/UHF
UNIT (rear view)
Cable TV
Converter Box
WARNING:
Overtightening “Nut type” RF coaxial cables may damage jacks. Finger tighten only.
VHF/UHF
VHF/UHF
IN from ANT./CABLE
Initial Setup (Ready to Play)
Press COMBO on the remote for Combo mode.
Plug the unit power cord into AC wall
1 outlet.
Press POWER on the remote or unit.
2 The unit comes on and auto channel and clock set starts.
If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page.
AUTO CLOCK SET
•If you use a cable box, turn it on and set it to the Public
Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off.
CH AUTO SET PROCEEDING
AUTO CLOCK SET
PROCEEDING
IS INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
Notes
CANCEL : STOP
Settings are made automatically. When
3 setup is done, this screen appears.
2/ 6/2003 THU 12:00PM
DST : ON
SETT ING : CH 10
AUTO CLOCK SET
COMPLETED
•Function buttons are inoperative during Initial Setup.
•To remove a cassette during Auto Set, press EJECT twice on the remote or STOP twice on the unit. In this case, settings must be made manually. (See page 10.)
•Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See page 10.)
8 | For assistance, please call : |
