TUNED/STEREO: Displayed when receiving stereo broadcasting
TUNED:Displayed when receiving monaural broadcasting or monaural sound is selected.
∫If noise is excessive
Press [AUDIO] to display “MONO”.
The sound becomes monaural.
Press the button again to cancel the mode. “AUTO STEREO” will be displayed on the main unit. Depending on the broadcast system, stereo or monaural will be selected. “MONO” is also canceled when you change the frequency.
≥This setting can be preset for each broadcasting station.
∫FM frequency step
Main unit:
The factory setting is set to 0.2 MHz, it can be changed to receive broadcasts allocated in 0.1 MHz. You may need to change this setting if the tuner seems to skip over the correct frequency for stations in your area.
1Press [SELECTOR] to select “FM”.
2 Press and hold [SELECTOR].
After a few seconds the display changes to show the current lowest frequency. Continue to hold the button down. The lowest frequency changes and the step is changed.
To return to the original settings, repeat steps 1 and 2.
≥After changing the setting, previously preset frequencies will be cleared. Preset them again.
Enjoying TV with unit’s speakers
Preparation
Turn on your TV and select the appropriate audio input mode [AUX, ARC,
|
| Surround sound effects | Playback | |
You can enhance stereo sources with surround sound effect. | ||||
| ||||
1 | Press [SURROUND] several times to select |
| ||
|
| the effect. |
| |
2 | While “MANUAL” is displayed on the unit’s display |
| ||
|
| Press [2, 1] and select the desired effect. |
| |
|
|
| Radio | |
|
| sources from all speakers: | ||
|
| Surround modes to enjoy TV audio or stereo |
|
≥DOLBY PRO LOGIC II MOVIE
≥DOLBY PRO LOGIC II MUSIC
≥SUPER SURROUND
For more detailed information on this operation, please refer to the “Enjoying surround sound effects” section on page 23.
| Sound modes |
| TV |
|
|
| |
You can adjust the mode depending on the source or situation. |
| ||
1 Press [SOUND] several times to select the |
| ||
| mode. |
| |
2 While the selected mode is displayed on the unit’s |
| ||
| display |
| |
| Press [2, 1] and select the desired setting. |
| |
For more detailed information on this operation, please refer to |
| ||
the “Changing the sound modes” section on page 23. |
| ||
|
|
|
|
| Selecting the type of audio |
|
|
| from the DIGITAL AUDIO IN |
|
|
| terminal |
|
|
1 Press |
| ||
|
|
| |
2 Press [AUDIO] several times to select the |
| ||
| type. |
| |
| MAIN |
| |
| SAP* |
| |
| MAIN+SAP* (stereo audio) |
|
*“SAP” = Secondary Audio Program (Only works with Dolby Dual Mono)
≥ “MAIN” or “SAP” is not available if “On” is selected in “Digital Audio Input”. (> 37)
≥Audio that is input through the DIGITAL AUDIO IN or AUX terminals are not output from the HDMI AV OUT terminal.
VQT2W18
29