Siemens 2602 manual Reboot the computer when prompted, Ports Color Condition Status

Figure 2-3. WAN Connection

Use unshielded or shielded twisted-pair Ethernet cable with RJ-45 plugs to connect the broadband modem directly to the WAN port on the SpeedStream 2602. Use either straight-through or crossover cable depending on the port type provided by the modem (see Appendix B, “Cables”).

4.Connect the power adapter and power up the router, modem and network computers. Plug the power adapter into the power socket on the SpeedStream 2602, and plug the other end into a power outlet. Check the Power indicator on the front panel to be sure it is on. If the Power indicator does not light up, refer to Appendix A, “Troubleshooting.”

5.Verify the port status. Confirm that all connections are successful by checking the power and port status indicators as shown in the following table.

LED	Ports	Color	Condition	Status
Power	n/a	Green	On	SpeedStream 2602 is receiving power.
WAN	n/a	Green	On	The WAN port has established a valid network connection.
			Flashing	The WAN port is transmitting or receiving traffic.
LAN
- Link/Act	1-2	Green	On	The indicated LAN port has established a valid network
				connection.
			Flashing	The indicated LAN port is transmitting or receiving traffic.
- 10/100	1-2	Amber	On	The indicated LAN port is operating at 100 Mbps.
			Flashing	The indicated LAN port is operating at 10 Mbps.

Table 2-2. LED Status Indicators

6.Configure the SpeedStream 2602. Configure the SpeedStream 2602 as detailed in Chapter 3, “Configuring the SpeedStream 2602.”

7.Configure TCP/IP. Configure the TCP/IP protocol on your network computers as detailed in Chapter 4, “Configuring Client TCP/IP.” If TCP/IP is not on your system, this chapter also includes installation instructions.

8.Reboot the computer when prompted.

2-5