Inserting media
The label side
≥Make sure to tilt the disc so as not to touch the sliding door.
≥Do not open the sliding door manually.
ENGLISH
Charging a device
Charging starts when a device (rated value: 5 V/1.5 A) is connected to the DC OUT terminal of this unit. Note that the port cannot be used for purposes other than supplying/charging power.
1 Turn the unit on.
2 Connect a device.
{.Confirm from the screen of the connected device, etc. to make sure charging has started.
To the compatible device
USB cable (not supplied)
≥A cable compatible with your device is required. Use the cable that comes with your device.
≥Even if you connect a cable compatible with the DC OUT terminal of this unit, your device may not be charged. In that case, use the charger that comes with the device.
≥Depending on your device, using other chargers may not work. Check the owner’s manual of your device before use.
≥Do not connect a device with a rated value higher than 5 V/1.5 A to this unit.
≥To check if charging is complete, look at the screen of the connected device, etc.
≥Once fully charged, remove the USB cable from the DC OUT terminal.
≥To continue charging during standby mode, make sure the device has started charging before turning the unit to standby mode.
–When charging a depleted device, do not turn the unit to standby mode until the device becomes operational.
≥Make sure that the unit does not fall when inserting or removing media.
≥When moving this unit, be sure to remove all media and turn this unit to standby mode.
7
RQT9882