≥Use only supplied speakers
Using other speakers can damage the unit, and sound quality will be negatively affected.
≥Set the speakers up on an even surface to prevent them from falling. Take proper precautions to prevent the speakers from falling if you cannot set them up on an even surface.
Main unit
[Note]
Keep your speakers at least 10 mm away from the system for proper ventilation.
Center speaker
≥Vibration caused by the center speaker can disrupt the picture if it is placed directly on the television. Put the center speaker on a rack or shelf.
≥To prevent the speakers from falling, do not place directly on top of the television.
Active subwoofer
Place to the right or left of the television, on the floor or a sturdy shelf so that it won’t cause vibration. Leave 10 cm at the rear for ventilation.
Caution
Do not stand on the base and shake the speaker.
Be cautious when children are near.
Notes on speaker use
≥You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.
≥Reduce the volume in the following cases to avoid damage:
–When playing distorted sound.
–When the speakers are reverberating due to a record player, a microphone (except [The[United[Kingdom,\Australia[and\N.Z.\), noise
from FM broadcasts, continuous signals from an oscillator, test disc, or electronic instrument.
–When adjusting the sound quality.
–When turning the unit on or off.
If irregular coloring occurs on your television
The supplied speakers are designed to be used close to a television, but the picture may be affected with some televisions and setup combinations.
If this occurs, turn the television off for about 30 minutes. The television’s demagnetizing function should correct the problem. If it persists, move the speakers farther away from the television.
Caution
≥The main unit and supplied speakers are to be used only as indicated in this setup. Failure to do so may lead to damage to the amplifier and/or the speakers, and may result in the risk of fire. Consult a qualified service person if damage has occurred or if you experience a sudden change in performance.
≥Do not attempt to attach these speakers to walls using methods other than those described in this manual.
Positioning/Connecting speakers with the subwoofer
STEP3 Connecting speakers with the subwoofer
≥Attach the
≥The terminals of the subwoofer have high output power. Carefully connect the speaker wires.
Speaker cables | Sheet of |
[HT530]
≥3 kshort cables: For front and center speakers
≥2klong cables: For surround speakers
[HT840]
≥1kshort cable: For center speaker
≥2klong cables: For surround speakers [HT880]
≥1kshort cable: For center speaker
ACTIVE
SUBWOOFER
| The illustration shows |
2 FRONT (R)
1 FRONT (L)
4 SURROUND (R)
3 SURROUND (L)
5 CENTER
Insert the wire fully. | [HT840] |
| |
[HT880] | [HT530] | ||
| |||
| Copper | White | |
Click! | Silver | Blue | |
|
|
[Note]
≥[HT840] [HT880] Even though the subwoofer shown is different, you can connect the speakers to the subwoofer in the same way. ≥Never
≥Be sure to connect only positive ([HT530]: white, [HT840] [HT880]: copper) wires to positive (i) terminals and negative ([HT530]: blue, [HT840] [HT880]: silver) wires to negative (j) terminals. Incorrect connection can damage the speakers.
RQT7978
7
