Inserting media, Inserting a disc, English

Inserting media

Select “CD” as the source.



10 cm (4q)

The label side

1Press [CD <] to open the lid on the back of the CD unit.

≥Leave a space more than 10 cm (4q) behind the unit.

≥Do not place any objects behind the unit.

2While holding the unit, push the center of the CD until it clicks into place, and then close the CD lid.

≥Be careful not to scratch the CD.

≥Make sure you place the center of the CD onto the CD spindle of the unit.

Note: Remove the CD only after it stops rotating.

ENGLISH

Select “IPOD_PORT” as the source.

≥ When connecting an iPod/iPhone/iPad, use the dedicated USB cable (not supplied).

Select “IPOD_DOCK” as the source.

Charging starts when an iPod*2/iPhone/iPad is connected to this unit.

≥During standby mode, charging will not start from the USB cable connection, however it will start as usual from the Lightning connector.

–To charge from the USB cable connection, start the charging before turning this unit to standby mode.

≥Check the iPod/iPhone/iPad to see if the battery is fully charged. (Once fully recharged, additional recharging will not occur.)

≥If this unit is switched to standby mode “IPOD CHARGING” is shown on the unit’s display.

≥Make sure that the unit does not fall when inserting or removing media.

≥When moving this unit, be sure to remove all media and turn this unit to standby mode.

*1: Refer to “Playable media” for compatible models. (l 5)

*2: When using the “IPOD_PORT” connection, do not connect the following models to this unit:

– iPod classic, iPod [4th (color display), and 5th (video) generation], iPod nano (1st generation)

Unexpected behavior may occur.

*3: When using the “IPOD_DOCK” connection:

≥Be sure to remove the iPod/iPhone from its case.

≥Make sure that the iPod/iPhone is fully inserted and its back is resting against the cushion pad.

≥Make sure to hold the dock when removing the iPod/

iPhone.

*4: Use the “IPOD_PORT” connection to charge the iPad.

(ENG) VQT4U55