Panasonic SC-NE5 owner manual Method, English, Connect the iPhone to the CD unit

Method 2

If you're using an iPod touch/iPhone/iPad. (iOS version 5.0 or later.)

With this method you will share the wireless network settings of your iPod touch/iPhone/iPad with this system.

≥The following explanations are based on an iPhone.

1 Disconnect any devices connected to the CD unit.

2 Connect the iPhone to your home wireless network.

3 Connect the iPhone to the CD unit.

Choose one of the following connections.

“IPOD_DOCK” connection compatible iPod touch/iPhone:

iPod touch/iPhone/iPad with iOS 5.0 or later: Connect to the iPod port on the side of the CD unit with a dedicated USB cable.

6 The settings are completed when “SUCCESS” is displayed and the Wi-Fi status indicator

stops blinking and lights in blue.

If “FAIL” is displayed press [OK] and try the setting again. If “FAIL” is still displayed, try other methods on page 10 or 12.

≥If the iPhone was disconnected midway through, try again without disconnecting it.

7 Press [OK] on the remote control to exit the settings.

*1: Depending on the network environment or the wireless network router settings, it may take more than 10 mins. to complete the settings.

ENGLISH

4 Unlock your iPhone and then press and hold [sNETWORK SETUP] on the CD unit for more than 3 seconds.

≥If “NOT SUPPORTED” or “SET WI-FI” is displayed, check that the iPhone is connected to the wireless network and try again from step 1.

5 A message will pop-up on your iPhone.

Allow the iPhone to share the wireless network settings.*1

{.The Wi-Fi status indicator blinks.

11

(ENG) VQT4U55