Others
Automatic standby
As a factory preset, this system will always turn off automatically if there is no sound output and no operation for approx. 30 minutes.
To cancel this function
1 Press [SETUP] repeatedly to select “AUTO OFF”.
2 Press [3, 4] to select “OFF” and then press [OK].
≥To turn automatic standby on, select “ON” in step 2.
≥This setting cannot be selected when “FM” is the source.
≥When connected to a Bluetooth® device, the automatic standby function does not work.
Changing the remote control code
When other Panasonic equipment responds to the supplied remote control, change the remote control code.
1 Press [, AUX] to select “AUX”.
2 While pressing and holding [SELECTOR] on the speaker unit, press and hold [CD/RADIO] on the remote control until this system's displays show “REMOTE 2”.
3 Press and hold [OK] and [CD/RADIO] on the remote control for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the steps above but replace the button pressed on the remote control
from [CD/RADIO] to [ , AUX].
Software update
Occasionally, Panasonic may release updated software for this system that may add or improve the way a feature operates. These updates are available free of charge.
The CD unit and the speaker unit need to be updated separately.
DO NOT DISCONNECT the AC power supply | ENGLISH | |
cord while one of the following messages is | ||
| ||
displayed. |
| |
– “LINKING”, “UPDATING” or “%” |
| |
(“ ” stands for a number.) |
| |
≥ During the update process, no other operations can be performed. |
| |
|
|
Preparation
≥Turn this system on.
≥Connect this system to the wireless network. (l 10)
–Make sure that the wireless network is connected to the Internet.
–If “D.CONNECT” is set to “ON”, change the setting to “OFF” and connect this system to a wireless network that is connected to the Internet.
∫Updating the CD unit
1Download the latest firmware from the following website and burn it to a
2Insert the
3Press [CD/RADIO] repeatedly to select “CD”.
4Press [3, 4] to select “UPDATE? Y” and then
press [OK] to start the update.
≥Select “UPDATE? N” to cancel the update.
{.After the update has finished, “SUCCESS” is displayed.
5Disconnect the AC power supply cord and reconnect it after 3 minutes.
∫Updating the speaker unit
1Press [SETUP] repeatedly to select “SW UPDATE” and then press [OK].
2Press [3, 4] to select “UPDATE? Y” and then press [OK] to start the update.
≥Select “UPDATE? N” to cancel the update.
{.After the update has finished, “SUCCESS” is displayed.
3Disconnect the AC power supply cord and reconnect it after 3 minutes.
≥If there are no updates, “NO NEED” is displayed.
≥Downloading will require several minutes. It may take longer or may not work properly depending on the connection environment.
∫Checking the software version
1 | Press [SETUP] repeatedly to select “SW VER.” and then |
|
| press [OK]. |
|
| {. The version of the installed software is displayed. | 21 |
2 | Press [OK] to exit. | |
|
|
|
(ENG) VQT4U55