Panasonic SC-PM18 manual Cassette tapes

OPEN1

STOP	, DEMO	2
	/FF,	3
	/REW

1 OPEN

Insert inside the guides

Forward side

2 TAPE

3 VOLUME

DOWN UP

Cassette tapes

1 Press [c OPEN], insert a cassette with the tape facing in.

When the button is pressed, the unit comes on automatically.

Make sure the cassette is fully inserted and close the lid by hand.

2 Press [TAPE 3] to start playback.

3 Adjust the volume.

To stop tape playback

Press [STOP L, –DEMO].

One-touch play
When the system is OFF and a cassette is already inserted,		operations
play starts automatically when you press [TAPE 3].
Fast-forward and rewind
Press [g 4/REW] (rewind) or [f 3/FF] (fast-forward)
in stop mode.
		Listening
Cassette tape selection and care
Types of tapes which can be played correctly.
The system automatically identifies the type of tape.
NORMAL POSITION/TYPE I	✓
HIGH POSITION/TYPE II	✕
METAL POSITION/TYPE IV	✕

High position and metal position tapes can be played, but the unit will not be able to do full justice to the characteristics of these tapes.

•Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.

•Tape slack can get caught up in the mechanism and should be wound up before the tape is played.

•Endless tapes can get caught up in the deck’s moving parts if used incorrectly.

To find the beginning of a program (TPS: Tape Program Sensor)

TPS finds the beginning of a track and resumes play from there. Each press increases the number of tracks skipped, up to a maximum of 9.

Press [g 4/REW ] or [f 3/FF] during play.

Notes

The TPS function searches for silent parts of about 4 seconds in length which are normally found between tunes. As a result, it may not function properly in the following cases:

•With short silent parts

•When noise occurs between tunes

•With silent parts found within tunes

17

RQT6683