Setup

2Close the LCD monitor while the mode dial is set to or .

A

The status indicator A flashes green and the unit goes into quick start standby mode.

3Open the LCD monitor.

A

The status indicator A lights red and the unit is put into recording pause approx. 1.7 seconds after it is turned on.

To cancel Quick start

Press the MENU button then [SETUP]

#[QUICK START] # [OFF] and then press the cursor button in the centre. ≥ The status indicator goes off and the

power turns off if the mode dial is set to OFF while the unit is in quick start standby mode.

≥ The status indicator goes off and the power turns off if quick start standby

mode continues for approx. 5 minutes.

Quick start standby mode is cancelled, the status indicator goes off and the power turns off in the following cases. jWhen the mode dial is switched.

When this unit is quick-started with the white balance on automatic, it may take some time until the white balance is adjusted if the scene being recorded has a light source different from the scene last recorded. (When the Colour night view function is used, however, the white balance of the scene last recorded is retained.)

When this unit is quick-started, the zoom magnification becomes 1k and the view may differ from what it was before quick start standby mode.

If [POWER SAVE] is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and then open it again.

25

VQT1E14

Page 25
Image 25
Panasonic SDR-S10 Close the LCD monitor while the mode dial is set to or, Open the LCD monitor, To cancel Quick start