Panasonic TC-P54Z1 operating instructions AttachingAttachinge pedestalthe pedestalto TV to TV

Back of Display Unit

Assembly screws

Accessories/Optional Accessory

AttachingAttachinge pedestalthe pedestalto TV (continued)to TV

Warning

Do not disassemble or modify the pedestal.

Otherwise the TV may fall over and become damaged, and personal injury may result.

Caution

Do not use any other TV and displays.

Otherwise the TV may fall over and become damaged, and personal injury may result.

Do not use the pedestal if it becomes warped or physically damaged.

If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately.

During set-up, make sure that all screws are securely tightened.

If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the TV, and it might fall over and become damaged, and personal injury may result.

Attaching the Speaker to TV

Fix the Mounting bracket securely to the back of the Display unit with Assembly screws .

Insert the speaker mounting screws temporarily in the screw outermost holes of the speaker and fix the speaker mounting screws to the speaker mounting bracket.

Orient the front side of the Mounting bracket toward the rear side of the speaker and Display Unit side.

Fix it same as the speaker at the other side.

There will be a gap between the Display Unit and the speaker.

Accessories

Speaker (2)

SP-54Z1U

Mounting bracket

Back of

Display Unit

Mounting bracket

[Top]

Mounting Assembly

bracket screws [Lower right]

Place the temporarily inserted screws into the counter sunk holes

on the bracket

Speaker

[Top] (2)

TXFKR04DLUJ

Front Back

[Lower right] (1)

TXFKR05DLUJ

Front Back

[Lower left] (1)

TXFKR06DLUJ

Front Back

Connect Display Unit and speaker with speaker cable.

Fix it in the same way as the speaker on the other side.

Speaker	Lower right	Assembly screws
	(Back of Display Unit)	TXFXY01DLUJB
		(8)	(8)
	Speaker	Speaker cable (2)
		TXJ/SPDKUU-1
To open the Clamper	cable
		Connect the terminal
Hook	Press the part and	near the ferrite core to
	remove the hook.	the Display Unit.

Note

Tighten the screws firmly.

Insert to the end of the speaker cable terminal firmly.

Loosen the screw shown in fig. A above to adjust the gap between the speaker and the Display Unit. Do not hold the speaker to transport the unit.

10