Basic Operation
Switching the projector on/off
Switching off the projector
When operating the projector, check the status of the POWER indicator. (Æpage 22)
(1), (2) |
INPUT SELECT |
RELEASE |
POWER indicator |
POWER LOCK indicator |
1111 Press the POWER button.
The confirmation screen will be displayed.
zzWithout any operation for 10 seconds or press any button other than the POWER button, the confirmation screen will go off and return to the projection.
2222 Press the POWER button again.
The lamp goes off, the operational sound (beep) sounds, and projection stops.
zzThe cooling fan continues its rotation and POWER indicator lights in orange. Wait until the POWER LOCK indicator and POWER indicator turn into red.
zzIf STANDBY MODE is set to NORMAL, the POWER indicator flashes in red. (Æpage 42)
zzYou can set to ON or OFF the beeping sound that occurs when the POWER button is in operation in
AUDIO SETTING.
(Æpage 43)
3333 After the POWER LOCK indicator and POWER indicator light in red, disconnect the mains plug from the mains socket. (Æpage 21)
zzFor urgency, you may disconnect the mains plug immediately since the DIRECT POWER OFF function is installed.
Remarks
zzConfirm that CONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when operating with the remote control) under CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE. (Æpage 46)
zzYou can switch off the power by pressing the POWER button for 0.5 seconds or more.
24 - ENGLISH
