Panasonic TU-HDT206A Installation of the Digital Receiver, 4.1Connection of the Digital Receiver

(B) YPbPr Connection

(C) HDMI Connection

Operating Instructions

TU-HDT206A

4 Installation of the Digital Receiver

4.1Connection of the Digital Receiver

The following illustrations show some examples for connecting this HD digital receiver. Select the connection that is best suited for your needs. Many other connections may be possible when optional devices such as RF cable splitters are included in your system. These devices may cause signal degradation and, if too many are used, poor quality picture and sound may result.

Terrestrial Antenna Cable Connection (A)

Connect the RF antenna cable to the HD digital receiver RF IN connector. Also connect the cable from RF OUT to the TV RF

IN connector on the rear of your television. This connection allows your TV set to receive normal analogue programs. (Refer to A)

(A) Aerial Connection

Video Connections

The HD digital receiver has several types of video connections. Please select from HDMI, YPbPr and RGB for high definition video, and VIDEO and S-VIDEO for standard definition video. The HDMI, YPbPr and RGB sockets detect when a plug is inserted and the digital receiver configures the video output to suit the connection type made to the display.

YPbPr Connection (B)

Connect the YPbPr component video output socket on your digital receiver to your display device’s YPbPr component video input. Be sure to match the colours on the RCA sockets with the coloured plugs. (Refer to B) At the start of the initial installation, the video format is set as HD Format 576p. The video format can be changed to other HD formats after the installation is finished by “V Format” on the remote control.

HDMI Connection (C)

Connect the HDMI output socket on your digital receiver to your display device’s HDMI input. The HDMI connection also includes audio signals set at a fixed level. (Refer to C)

The HD digital receiver can also be connected to a DVI input on a display.

Please check that DVI input can display the digital receiver HD video formats. A HDMI to DVI

cable (not supplied) is required for this. Also the audio needs to be connected by the RCA connector (red/white) cable. Note: If HDMI cable is removed when the digital receiver is switched on, the OSD will NOT change to any other video output terminal. The receiver must be switched off when the HDMI cable is removed.

7