Panasonic TU-HDT206A manual Teletext Operation, To Update Manually, USB Software Upgrade

Operating Instructions

TU-HDT206A

To Update Manually

Perform “Viewer Prompt To Update”.

Access the on screen display. Press OK to set the digital receiver to start searching for the OAD immediately. All video and audio is stopped for several minutes while the updating sequence is in progress.

Note: Recommended method is to use “Update Automatically”.

USB Software Upgrade

The operating software of the digital receiver can also be upgraded via a USB port. The USB port is located on the rear of the receiver and is covered by a sticker. The new software has to be loaded on a USB flash drive. The flash drive is plugged in to the USB port and the software is automatically loaded when the digital receiver is switched on. Please follow the displayed instructions.

6.6Diagnostic Information

From here, you can get general information about the digital receiver including the serial number ID, software version and hardware version.

7 Teletext Operation

Teletext is only available on certain broadcast channels. The time taken to display the pages and sub-pages is set by the teletext transmitter. Teletext is also used for Closed Captioning of television programmes for the hearing impaired. Closed captions can be found on Teletext Page 801. The picture remains on the screen while you type in 801.

Some broadcast stations will have a message on the screen to tell you that closed captions

are not available for this programme. Some broadcast stations give you no indication at all.

TOP (Table of Pages) MODE

In TOPTEXT mode, the red button moves to the previous page number and the green button moves to the next page number. The yellow and blue buttons correspond to different subjects. Pushing the coloured button can access these subjects. This is the current preferred method of operation in Australia.

Red /Green / Yellow / Blue buttons

In TOP TEXT mode these correspond to the differently coloured subjects.

19