Cisco EtherSwitch Service Modules Feature Guide
Troubleshooting the Cisco EtherSwitch Service Module Software
| Command or Action | Purpose |
Step 8 |
|
|
dir flash: | Displays a list of all files and directories in flash memory on | |
|
| the service module. |
| Example: |
|
| switch> dir flash: |
|
Step 9 |
|
|
boot flash: image | Boots the Cisco EtherSwitch service module image if all | |
|
| files and directories are in flash memory on the service |
| Example: | module. |
|
| |
| switch> boot |
|
|
|
|
Troubleshooting
If the downloaded image (files and directories) are not in flash memory on the Cisco EtherSwitch service module, repeat Step 1 through Step 6. If the procedure fails again, ensure that your TFTP connection is up and that your TFTP session is open when you download the image.
Examples
This section provides the following examples:
•Sample Output for the copy flash: xmodem Command, page 69
•Sample Output for the copy tftp: xmodem: Command, page 70
•Sample Output for the
•Sample Output for the dir flash: Command on the Cisco EtherSwitch Service Module, page 71
•Sample Output for the
•Sample Output for the flash_init Command on the Cisco EtherSwitch Service Module, page 72
Sample Output for the copy flash: xmodem Command
The following example shows what appears when you enter the copy flash: xmodem command:
Router# copy flash: xmodem
**** WARNING ****
x/ymodem is a slow transfer protocol limited to the current speed settings of the auxiliary/console ports. The use of the auxiliary port for this download is strongly recommended.
During the course of the download no exec input/output will be available.
Proceed? [confirm]
You are prompted for the source filename and destination filename:
Source filename [loader_bs.img]?
Destination filename [loader_bs.img]?
You are prompted for the Cisco EtherSwitch service module slot number:
Service Module slot number? [1]:
Cisco IOS Release 12.2(25)SEC
69
