Cisco EtherSwitch Service Modules Feature Guide
Troubleshooting the Cisco EtherSwitch Service Module Software
You are prompted for the service module interface number. Accept the default:
Service Module interface number? [0]:
You are prompted to confirm the buffer. Accept the default:
1k buffer? [confirm]
You are prompted for the max retry count. Accept the default:
Max Retry Count [10]:
You are prompted to confirm the transfer to the Cisco EtherSwitch service module:
Xmodem send on slot 2 interface 0. Please be sure there is enough space on receiving side. Continue? [confirm]
The following appears when the image is downloaded to the service module:
Ready to send
file...........C!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!
262144 bytes copied in 101.744 secs (2577 bytes/sec)
Sample Output for the copy tftp: xmodem: Command
The following example shows what appears when you enter the copy tftp: xmodem: command:
Router# copy tftp: xmodem:
**** WARNING ****
x/ymodem is a slow transfer protocol limited to the current speed settings of the auxiliary/console ports. The use of the auxiliary port for this download is strongly recommended.
During the course of the download no exec input/output will be available.
Proceed? [confirm]
You are prompted for the IP address of the TFTP server:
Address or name of remote host []? 223.255.254.254
You are prompted for the source filename and destination filename:
Source filename [loader_bs.img]?
Destination filename [loader_bs.img]?
The following appears when you are connected to the TFTP server:
Accessing tftp://223.255.254.254/anyname/loader_bs.img...
You are prompted for the Cisco EtherSwitch service module slot number:
Service Module slot number? [1]:2
You are prompted for the service module interface number. Accept the default:
Service Module interface number? [0]:
You are prompted to confirm the buffer. Accept the default:
1k buffer? [confirm]
Cisco IOS Release 12.2(25)SEC
70
