Cisco EtherSwitch Service Modules Feature Guide
How to Configure the Cisco EtherSwitch Service Module
Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Sample Output for Entering an Interface Name
The following example shows what appears when you enter an interface name:
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Sample Output for Assigning the IP Address and Subnet Mask
The following example shows what appears when you configure the Cisco EtherSwitch service module IP address and subnet mask:
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Sample Output for Configuring the Cisco EtherSwitch Service Module as a Standalone Service Module
The following example shows what appears when you configure the Cisco EtherSwitch service module to run as a standalone service module:
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the Cisco EtherSwitch service module, which displays its initial configuration. This is an example of output that appears:
The following configuration command script was created: hostname Switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1 enable password enable_password
line vty 0 15
password
!
no ip routing
!
interface Vlan1 no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
!
interface GigabitEthernet2/0/28
!
end
Cisco IOS Release 12.2(25)SEC
47
