Cisco Systems NME-16ES-1G manual Setting the Stack Member Priority Value

Cisco EtherSwitch Service Modules Feature Guide

How to Configure the Cisco EtherSwitch Service Module in a Switch Stack

Sample Output for the show switch Command

The following example shows what appears when you enter the show switch command:

Switch# Role Mac Address Priority State

--------------------------------------------------------

6 Slave 0003.e31a.1e00 1 Ready

*8 Master 0003.e31a.1200 1 Ready

2 Slave 0000.000.0000 0 Provisioned

Setting the Stack Member Priority Value

This section describes how to assign a priority value to a Cisco EtherSwitch service module in a switch stack from global configuration mode.

Note This task is available only from the stack master.

SUMMARY STEPS

1.configure terminal

2.switch stack-member-number priority priority-number

3.end

4.show switch stack-member-number

DETAILED STEPS

	Command or Action	Purpose
Step 1
	configure terminal	Enters global configuration mode.
	Example:
	Switch# configure terminal
Step 2
	switch stack-member-number priority	Specifies the stack member number and the new priority
	priority-number	value for the stack member. The priority value range is 1 to
		15.
	Example:	• You can display the current stack member number by
	Switch (config)# switch 1 priority 2	using the show switch user EXEC command.
Step 3
	end	Returns you to privileged EXEC mode.
	Example:
	Switch (config)# end
Step 4
	show switch stack-member-number	Displays information about the switch stack and its stack
		member number.
	Example:
	Switch# show switch

Cisco IOS Release 12.2(25)SEC

54