Cisco Systems NME-16ES-1G manual Service-module interface slot/port, Password-reset, Flashinit

Cisco EtherSwitch Service Modules Feature Guide

Troubleshooting the Cisco EtherSwitch Service Module Software

7.service-module interface slot/port session

8.dir flash:

9.boot flash: image

DETAILED STEPS

	Command or Action	Purpose
Step 1
	service-module interface slot/port	Ensures that the switch stays at the boot loader prompt, so
	password-reset	that you can copy a new image through the Xmodem
		Protocol.
	Example:
	Router# service-module gigabitethernet2/0
	password-reset
Step 2
	flash_init	Initializes the flash memory file system on the switch.
	Example:
	Switch: flash_init
Step 3
	load_helper filesystem:/file-url ...	Loads and initializes one or more helper images.
	Example:
	Switch: load_helper flash: xyz
Step 4
	control+6 x	Returns you to the router console while keeping the console
		session to the switch intact.
	Example:	(Use x to get back to the router prompt.)
	Switch: control+6 x
Step 5
	disconnect	Disconnects the switch session to begin the Xmodem
		download.
	Example:
	Router# disconnect 1
Step 6
	copy flash: xmodem:	Starts the file transfer from the router flash memory by
		using the Xmodem Protocol from the router prompt.
	Example:
	Router# copy flash: xmodem:
	or
	copy tftp: xmodem:	Starts the file transfer from a TFTP server from the router
		prompt.
	Example:
	Router# copy tftp: xmodem:
Step 7
	service-module interface slot/port session	Connects to the service module and opens a Cisco
		EtherSwitch service module session.
	Example:
	Router# service-module gigabitethernet1/0
	session

Cisco IOS Release 12.2(25)SEC

68