Cisco Systems NME-16ES-1G manual Sample Output for the rcommand and show version Commands

Cisco EtherSwitch Service Modules Feature Guide

How to Configure a Switch Cluster

	Command or Action	Purpose
Step 3
	exit	Exits privileged EXEC mode on the cluster member service
		module to return to the command service module CLI.
	Example:
	Switch-3# exit
Step 4
	show cluster members	Displays information about the cluster members.
	Example:
	Switch# show cluster members

Examples

This section provides the following examples:

•Sample Output for the rcommand and show version Commands, page 59

•Sample Output for the show cluster members Command, page 59

Sample Output for the rcommand and show version Commands

The following example shows what appears when you enter the rcommand command on the command switch to see the software version running on the cluster member 3:

Switch# rcommand 3

Switch-3#show version

Cisco Internet Operating System Software ...

...

Note Access to the member-switch CLI is at the same privilege level as on the cluster command switch. The Cisco IOS commands then operate as usual. Therefore, if you use the rcommand command on the cluster command switch at the privileged level, the command accesses the cluster members at the privileged level.

Sample Output for the show cluster members Command

The following example shows what appears when you enter the show cluster members command:

Switch# show cluster members ---Upstream---

SN MAC Address Name PortIf FEC Hops SN PortIf FEC State 0 0002.4b29.2e00 StLouis1 0 Up (Cmdr)

10030.946c.d740 tal-switch-1 Fa0/13 1 0 Gi0/1 Up

20002.b922.7180 nms-2820 10 0 2 1 Fa0/18 Up

30002.4b29.4400 SanJuan2 Gi0/1 2 1 Fa0/11 Up

40002.4b28.c480 GenieTest Gi0/2 2 1 Fa0/9 Up

Cisco IOS Release 12.2(25)SEC

59