Operating Instructions
Manual Channel Search
In the “Manual Channel Search” window you can set the specific channel to search. Press the left or right button then OK to select the broadcast RF channel you wish to search.
Note: The RF channel is not the same number as the station identification.
Region Select
Using cursor buttons 
select the region you live in. This setting will allow the digital receiver to display the current time on the information banner and on the control panel when the receiver is in the
Restore Default Setting
If you need to reset all the digital receiver settings to the factory shipping settings, this feature will do so. Once restore default settings has been done, the installation procedure of the STB will need to be done again. Please be very careful before you confirm this action.
Receiver Software “System Update”
This digital receiver software can be updated to the latest version software by “over air download” (OAD).
To Update Automatically
Set “Allow Software Updates” to “Yes”. If there is a new software version being broadcast, the digital receiver will download this automatically. The automatic updating sequence happens when the digital receiver is switched to
standby and at approximately 3:30am nightly. The automatic updating sequence takes several minutes to find and upgrade to new software and then switch back to standby. The digital receiver will NOT perform the automatic update sequence if it is switched on. Changing the setting to” No” stops the digital receiver from receiving any software updates automatically.
18
