![](/images/new-backgrounds/1119415/11941549x1.webp)
Setting the Electronic Pen and Eraser
Setting the Electronic Pen and Eraser
Setting the Electronic Pen
1 | Remove the battery cover on the pen holder, |
insert the batteries as shown in the figure, and |
• Always use “LR03 (AAA size)” (alkaline) batteries and be sure that their polarity is properly oriented.
• Do not mix old and new, different type batteries when replacing batteries.
Battery cover
| 2 |
| 1 |
| 3 |
| Pen holder |
2 | Remove the temporal cap, and set the cap |
and adaptor to the marker for interactive. |
•Securely push the adaptor into the marker for interactive as far as it will go.
•Do not remove the color identification cap on the back end of the marker.
3 | Rotate the pen holder lever to the release |
position, insert the marker for interactive, and |
then return the pen holder lever to the lock position.
• Lock the pen holder lever while inserting the marker all the way into the pen holder until you hear a buzzing sound.
Detection of the marker color may not work well unless the marker is inserted fully into the pen holder.
• Do not set the marker near the Interactive Panaboard while using the interactive function as this may appear unnecessary streaks not written on the computer screen.
2 | Inserting |
Marker for | 3 Locking |
interactive |
|
| 1 Releasing |
| Pen holder lever |
2 - 3 mm
(1/16" - 2/16")
Note
Using
Remove the
Marker for interactive
• Press down firmly with the point of the |
Electronic Pen on the screen film until you hear |
a buzzing sound. |
temporal cap.
Color identification cap
1
Adaptor
Cap
2
3
• For precise positioning, keep the Electronic |
Pen perpendicularly to the screen during use. |
Inclined pen angle will cause the shift of |
position. |
25