Panasonic UB-8325 operating instructions Optional Wall-mounting Kit KX-B063, Pre-requisites

Optional Wall-mounting Kit (KX-B063)

Before attempting installation of this wall-mounting kit, we strongly recommend consulting with the building manager, engineer, or architect. The installer needs to know the type of construction used for the wall intended for this installation and the location of wall studs. Selection of hardware is critical for safe wall-mounting, and depends on the nature of wall construction. Installation should not occur until this consultation takes place.

Caution

•Do not attach the electronic board to mortared walls. Accidental electric leakage from the wall-mounting fixture bolts to metal laths or wire laths can cause heat, smoke or a fire.

1. Tools required:

A minimum of eight (8) pieces of appropriate wall-support hardware (molley, toggle, etc.)

NOTE: THIS HARDWARE MUST BE LOCALLY PROCURED, IT IS NOT INCLUDED IN THE KIT.

Drill (and drill bit of correct size) for hardware installation

Screw driver (Both phillips (+) and slotted (–) will be required.)

Tape measure

Tape or thumb-tacks (2 pcs)

Bubble type level

2.Pre-requisites

1.Before installation, make sure that the wall intended for installation is capable of supporting flush- mounted.

UB-8325 is 103 kgf (227 lbs.).

2.The position of the intended installation is of adequate size for the selected Panaboard. UB-8325 is 1,516 mm (H) ⋅ 1,550 mm (W) [5' (H) ⋅ 5' 2" (W)].

3.An outlet is within 3 m (9' 101/8" ), and not located behind the Panaboard.

■Accessories

The package box for the optional wall-mounting kit includes the parts noted below; please confirm that all parts are present before beginning installation. Eight screws for mounting the fixtures on the wall are not provided. Please purchase the appropriate wall-mounting hardware (sold in stores). Refer to page 98.

No.	Part name	Illustration	Q’ty	No.	Part name		Illustration	Q’ty
	Wall-mounting		2		Screw			4
	fixture L				(Not use*)
							M4 x 16 mm (20/32”)
	Wall-mounting		2
	fixture R
					Wall-mounting
					template			1
						Use the wall-
					(Not use*)
						mounting template
	Wing bolt	M5 x 12 mm (15/32”)	2			provided with
						UB-8325.
		(For mounting of the
		electronic board)

*These are used for other models.

96