Panasonic WV-CP304, WV-CP310, WV-CP314, WV-CP300 Manual fine adjustment of white balance, Step

Step 1

Set "WHITE BAL" to "AWC" and press the [left] button to change to "AWC → PUSH SET".

Step 2

Press the [SET] button and adjust the white balance. "AWC → PUSH SET" is reversely high- lighted during adjustment. When the reversely highlighted display is restored, the white balance adjustment is completed.

Step 3

Press the [right] button to select "AWC". Refer to this page for fine adjustment of the white balance.

Note:

•The adjustment of the color temperature ranges from approx. 2,000 K to 10,000 K. If the range is out of this adjustment range or lighting directed to a subject is too dark, the white balance may not be adjusted. In such a case, "AWC → PUSH SET" stays reversely highlighted.

Manual fine adjustment of white balance

The white balance is manually fine adjusted after white balance automatically adjustment in the automatic color temperature tracking mode (ATW1, ATW2) or automatic white balance control mode (AWC).

Follow the procedures below.

“CAMERA SETUP” screen		Fine adjustment screen				Area setting screen
**CAMERA	SETUP**		**ATW1**(1)			**ATW1 AREA**(1)
SCENE1			...I...		0
ALC/ELC	ALC	R				POSITION	PUSH SET
SHUTTER	OFF		-	+
AGC	ON(HIGH)	B	...I...		0
SENS UP	OFF
WHITE BAL	ATW1		-	+
DNR	HIGH
D&N(IR)	AUTO1	AREA
VMD	OFF					RESET
RET TOP END		RET TOP END				RET TOP END

Step 1

Set "WHITE BAL" to "ATW1", "ATW2" or "AWC" and press the [SET] button.

→The fine adjustment screen appears.

Step 2

Move the cursor to "R" and "B" and use the [left] or [right] button to fine adjust the level for each. “R” stands for red and “B” stands for blue. When the level indicator moves in the "+" direction, the color becomes deeper, and when the level indicator moves in the "–" direction, the color becomes lighter.

Step 3

Move the cursor to “AREA” and press the [SET] button to enter “AREA” setting screen.

The area to detect white area of white balance can be set on the area setting screen. The area to detect white area of white balance is displayed full-screen by default.

To change the white balance detection area, start from step 4.

14