Panasonic WV-CP310, WV-CP314, WV-CP304, WV-CP300 operating instructions

CP300	AUTO: Similar to the basic functions of AUTO1, but does not change the IR filter.
	Switches to black-and-white images when brightness (illuminance) around the
	camera is lower than approx. 0.1 lx.
	OFF (default): Displays color images.

Note:

•CP310 When “AUTO1” or “AUTO2” is selected, it is recommended to set “AGC” to “ON”.

•If a subject is always moving or the screen is occupied with a uniform color, brightness determination may not be performed successfully because the brightness is merely deter- mined by information from the CCD image sensor. When "AUTO2" is selected, the wave length of the light source shall be 800 nm or longer.

•WV-CP300 and WV-CP304 cannot set the switching brightness (illuminance) level of color images and black-and-white images.

•To obtain color images, a sufficient level of illuminance (approx. 30 lx or more) is required.

Step 2 CP310

Press the [SET ] button.

→The "D&N (IR)" screen appears.

Step 3 CP310

Move the cursor to "LEVEL" and select a brightness level at which switching between color and black-and-white images is performed from the following.

LOW: Switches from color to black-and-white images when the ambient brightness (illumi- nance) of the camera is less than 0.1 lx.

HIGH (default): Switches from color to black-and-white images when the ambient brightness (illuminance) of the camera is less than 0.2 lx.

Note:

•The switching illuminance level varies with subjects, light sources, and lenses.

•The switching illuminance level varies in accordance with AGC setting. ( page 12)

•The switching illuminances described above are reference values. The switching illumi- nance shall be decided based on the actual installation environment.

•There may be repeated switching between color and black-and-white images depending on the setting and environment.

Step 4 CP310

Move the cursor to "DURATION TIME" and select a time for switching between color and black-and-white images from the following.

2 S - 10 S (default) - 30 S - 60 S

(S)	(L)
Step 5	CP310

Move the cursor to "BURST (BW)", and decide whether or not to provide a burst signal output in the black-and-white mode.

ON (default): Provides a burst signal output.

OFF: Does not provide any burst signal output.

16