Panasonic WV-CW484 operating instructions Privacy Zone Setting Privacy Zone

**ZONE NUMBER 1/8**

RET TOP END

**ZONE NUMBER 1/8**

→When AUTO1 or AUTO2 is selected, LEVEL and DURATION TIME appear.

3.Select a threshold LEVEL to switch between the color and black-and-white mode. The default setting is HIGH.

HIGH: Switches the mode at approx. 5 lx illu- mination.

LOW: Switches the mode at approx. 1 lx illu- mination.

**BW MODE**

BW	AUTO1
LEVEL	HIGH
DURATION TIME .I..
	S L
BURST(BW)	ON

RET TOP END

4.Select a duration time to determine whether

to switch the mode. The default setting is 30 seconds. Available time: (Short) 10 s ↔ 30 s ↔ 60 s ↔ 300 s (Long)

5.Select a burst signal mode. The default setting is ON.

ON: Supplies the (color) burst signal with black-and-white composite video.

OFF: Supplies no burst signal.

Note: Using ON is usually recommended. Try both ON and OFF to match to connected devices (recorders, monitors, etc.) that have different characteristics.

12. Privacy Zone Setting (PRIVACY ZONE)

Perform settings of up to eight privacy zones where you wish to veil the monitor screen.

1.Select ON(1), ON(2) or OFF for PRIVACY ZONE on page 2 of the CAMERA SETUP menu and press the [SET] button. The default setting is OFF.

ON (1): Veils the zone with grey.

ON (2): Veils the zone with mosaic.

OFF: Displays pictures normally.

→The ZONE NUMBER selection menu opens.

2.Select a zone number on the top line using the [LEFT] and [RIGHT] buttons and press the [SET] button. The zone number followed by an asterisk * indicates that it has been already registered.

→POSITION, SCALE, and a frame appear on the menu.

3.Select →PUSH SW for POSITION and press the [SET] button.

→Position selection becomes available.

POSITION	→PUSH	SW
SCALE	→PUSH	SW

SET DEL

RET TOP END

4.Move the picture portion to be veiled to the center of the frame using the [LEFT], [RIGHT], [UP], or [DOWN] button.

39