Panasonic WX-C3010 manual ID registration for follower units

■ID registration for follower units

•To talk with the headsets (Order Taker and All-in-One Headset), ID registration is required.

•For ID registration, set the center module in ID registration mode and make operation of ID registration by means of a follow- er unit.

ID registration procedures are described below based on the All-in-One Headset.

1. Turn on the power of the Center Module.

Hold down the ID Registration Button for 2 seconds or more.

2.Press the ID Registration Button of the center module for 2 seconds or more. The system is changed to the ID Registration mode. The ID Registration Indicator blinks.

3.While holding down the buttons T1 and T2 simultaneous- ly, hold down the power button to turn on All-in-One Headset. The All-in-One Headset enters the ID Registration setting mode where the indicators and but- tons have different functions than in normal operation. You will hear "ID Registration Mode" and the power indi- cator will blink yellow.

d

Press the Power ON/OFF Switch to turn on.

4.Press the T1 button, the All-in-One Headset searches for the center module. You can hear "Connecting center module A" and the lane Indicator will blink yellow.

*Press the T2 button (at double-drive-thru), for other cen- ter modules. You can hear "Connecting center module B" and the lane indicator will blink green.

When the ID Registration succeeds, you will hear "Registration Complete" and the headset number, and the power indicator stops blinking and stays on.

5.When IDs are registered on all All-in-One Headsets, press the ID button of the center module, ID registration mode is completed. The power indicator of the All-in- One Headset will change from yellow to green.

Notes:

•If ID registration fails, a warning sounds "beep, beep, beep, beep" and then you will hear a voice prompt say "Failed". If registration fails, the ID is not registered and the "POWER" indicator blinks red.

If this happens, turn off the power and try registering again.

•All-in-one headset or Order Taker that can register in one center module is up to 32.

If you register IDs exceeding 32, the unused ID that has been registered is automatically deleted in chronological order.

•When registering the IDs of two or more All-in-one Headset or Order Taker, register each headset or Order Taker in order.

Hold down the Power Button to turn on.

SERVICE
USE ONLY	POWER

Holding down simultaneously.

25