LOADING THERibbonSpindleRIBBONRewind | RibbonSpindleSupply | Label |
Print Head | TopAccessDoorAccessDoorSide |
Assembly |
|
1.Open the Top Access Door by swinging it up and to the left and the S i d e A c c e s s D o o r by swinging it toward the rear of the printer.
2.Open the Print Head by rotating the Head Latch toward the rear of the printer. The Print Head is
3.Locate the Extra Ribbon Core supplied with the printer. Place
the core on the Ribbon Rewind Spindle, pushing it all the way to the inside of the spindle. Note that the new empty core of each subsequent roll becomes the next rewind core.
4.Load the ribbon onto the Ribbon Supply Spindle, also pushing it all the way to the inside of the spindle. The dull side of the ribbon should be facing down as it travels through the Print Head Assembly.
5.Feed the leader portion of the ribbon through the Print Head Assembly and up to the Ribbon Rewind Spindle following the routing shown in the
14 diagram.