Panduit PTR3E manual Service Mode Test Print Mode, Priority Setting Command Lcd

INITIALIZING ROM V00.00.00.00

TEST PRINT MODE

CONFIGURATION

TEST PRINT SIZE 10 CM

Note: This display does not appear when a Memory Test Print is chosen. Only a small Memory Test Print label can be printed.

PRESS FEED KEY TO STOP PRINTING

PRIORITY SETTING COMMAND LCD

This selection allows the user to assign a priority for Print Darkness, Print Speed and Print Offset.

1.Use the LINE key to step to the desired priority. If LCD is selected, the setting established via the LCD display/menu system will be used for an incoming label job, regardless of any different command settings. If Command is selected, any commands in the label job will take precedence and be used for printing the job and the LCD Display will reflect the new setting.

2.Once the desired setting is selected, press the FEED key to accept the setting and step to the next display.

SERVICE MODE

TEST PRINT MODE

The Service mode is exited by powering the printer off and then back on.

The Test Print Mode offers five different printer status labels for troubleshooting. If DSW3-5 is On, the Test Print cycle must be initiated with a Print Start command.

This option allows you to print a test label. It is recommended that you print a test label after have changed any of the settings in the Advanced Mode. The test label allows you to verify that you indeed did make the desired changes. To enter the User Test Print Mode, power the printer on while pressing the FEED key. The printer will beep. Release the FEED key and the printer will display the Test Print Mode message on the LCD panel:

1.Use the LINE key to step the underline cursor to the type of test labels you wish to print. The choices are:

Configuration Bar Code Head Check Memory Factory

Once you have selected the type of test label to be printed, use the FEED key to accept the selection and the display advances to the Test Print Size display. This display allows you to select the label width.

1. Use the LINE key to select the label width. Each time the LINE key is pressed, the label size advances 1 cm until it reaches a maximum width of 10 cm, at which point it will wrap to the smallest size of 4 cm.

2.Pressing the LINE key accepts the selection

3.Press the FEED key to start printing test labels

continuously.

4.Press the FEED key to stop the printer.

5.To exit the Test Print Mode, power the printer off

and then back on. 33