25 |
|
|
|
|
|
|
|
| 95 LOW HEIGHT NUT |
|
|
|
| 78 |
|
|
|
| 78 |
|
|
|
| 15 |
|
|
|
| 96 3/8 X 1” |
87 | 1/2 | X 3” |
| BUTTON |
| HEAD | |||
|
|
| 92 | |
|
|
|
| |
|
|
| 11 |
|
|
|
| 37 |
|
| 50 |
|
| 51 |
FIGURE 17 |
|
|
| 46 |
STEP 17
•Insert two 1/2” FLANGE BEARINGS (78) into the LEG CURL/EXT (15) as shown on FIGURE 17.
•Assemble the LEG CURL/EXT (15) to the FRONT UPRIGHT (25) using one 1/2 X 3” BOLT (87) and one 1/2” LOW HEIGHT NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the LEG CURL/EXT to rotate freely.)
•Assemble two ROLLER PADS (37) to the ROLLER PAD ADJUST (11) using two STARLOCK COLLARS (50).
•SECURELY assemble one 3/8” SPRING PIN (51) to the ROLLER PAD ADJUST (11) as shown in FIGURE 17.
•Slide ROLLER PAD ADJUST (11) over the LEG CURL/EXT (15) until the spring pin pops into the holes. See FIGURE 17.
•SECURELY assemble one 3/8 X 1” BUTTON HEAD CAP SCREW (96) and one 3/8” LOCK NUT (92) to the last hole in the LEG CURL/EXT (15) as shown in FIGURE 17.
•Insert one 2” SQ. END CAP (46) into the end of the LEG CURL/EXT (15) as shown in FIGURE 17.
16
