![](/images/new-backgrounds/1163504/16350439x1.webp)
I/O Map
Acroloop I/O Layout
Control Signals
These bits
The MotionCore.DLL depends on these bits so don’t use them in your Vb programs for any other purpose than as defined below. If you need to use some bits for your program logic, we have set aside some User Scratch Pad bits at bit locations
Bit |
| Description |
128 | Cycle Start | Set by AcroBasic to Signal that Cycle Start has been pressed. |
129 | Estop | Signals that Estop is On or Off. |
130 | Reset | Signals |
131 | Feedhold | Signals |
132 | Dry Run | Signals |
133 | Auto/Step | Signals control to Run in Auto or Step mode Auto=1 Step =0 |
134 | OK to Run | If Not in Feed Hold, Estop, MDI Mode or Jog Mode (This Signal Is Set by ACR- |
MOTIONMAX) |
| |
135 | Jog Mode | Set by |
136 | MDI Mode | Set by |
137 | Offsets Mode | Set By |
138 | In Cycle | Set by |
139 | Edit Mode | Set by |
140 | JoggedInCycle | Set by |
141 | ReturnToPreJogPos | Used by Mill max after a InCycle jog |
142 | OptionalStopActive | When=1 Optional Stop will be acted on else they will be ignored |
143 | Control Ready | Set In |
144 | Homing Active | Set In AcroBasic to Signal that a Homing operation is in progress |
145 | Control Initialized | Signal set by AcroBasic that Initialization succeeded to |
146 | Spindle Encoder Installed Used by | |
147 | M Done | Set by AcroBasic to Signal that a M code has finished successfully |
148 | S Done | Set By AcroBasic to Signal that a S code has finished successfully |
149 | T Done | Set By AcroBasic to Signal that a T code has finished successfully |
150 | M Strobe | Set By |
AcroBasic |
| |
151 | S Strobe | Set By |
AcroBasic |
|
20 - I/O Map | API Users Guide |