Patton electronic user manual Standalone Unit Installation, Vlink Data & Voice 1068

3.0 INSTALLATION

Because the VLINK modem requires no configuration, it can be installed quickly. If you are installing a standalone unit, refer to section 3.1 “Standal- one unit installation”. Otherwise, refer to section 3.2 “Rack card installation”.

Note If asymmetric transmission or line rates other than 12.5 Mbps are required, refer to section 4.0, “Configuration” on page 13.

3.1 STANDALONE UNIT INSTALLATION

Do the following:

1.Connect the line interface between the units (refer to section 3.3, “Connecting the Twisted-Pair Line Interface” on page 10)

Note See Figure 2 for the standalone unit’s rear panel arrangements.

2.Connect the Ethernet interface (refer to section 3.4, “Connecting the 10/100Base-T Ethernet Interface” on page 11).

3.Connect the power plug (refer to section 3.6, “Connecting Power” on page 12).

VLINK Data & Voice

1068

USA

in	the
Made

Ethernet Power

Line

Power

jack

Ethernet

port

VDSL twisted-pair

terminal block

interface

VDSL twisted-pair

RJ-45 interface

POTS/ISDN twisted-pair terminal block interface

Figure 2. VLINK modem standalone rear panel

Note The VDSL twisted-pair terminal block interface is included on Model 1068DV/TB45 only.

8