Switch S2-7: Reset Software Defaults. Switch S3-7 allows the user to reset the software configured factory defaults. This will only be needed when using the Model 1001MC to SNMP manage your units. For more information, please refer to the Model 1001MC Operations Manual.
S3-7 | Setting |
| |
On | Normal Operation |
Off | Reset |
| |
Switch S2-8: Transmit Data (TD) Sampling Point. Switch 3-8 controls the Transmit Data (TD) sampling point.
S3-8 | Setting | Description |
| | |
On | Normal | TD sampled on the falling edge of the 1088 Trans- |
| | mit Clock (TC) |
| | |
Off | Invert | TD sampled on the rising edge of the 1088 Transmit |
| | Clock. |
| | |
3.2 NETLINK PLUG-AND-PLAY
The NetLink Plug-and-Play feature allows ISPs, carriers and PTTs to quickly upgrade the link speed for a customer without requiring a visit to re-configure the Customer Premise (CP) Model 1088. This feature also allows service providers to set up all of the configurations at the Central Office (on the rack cards) before installing the stand alone units, saving time spent configuring or re-configuring DIP switches.
Note NetLink Plug-and-Play is only available when using a rack- mounted NetLink Model 1095RC as the CO unit.
The NetLink Plug-and-Play feature allows the user to configure the DTE rate (bandwidth allocation, see Switches S2-1 through S2-6) of the CP unit from the rack card at the Central Office (CO). The stand alone unit at the Customer Premise (CP) site will automatically configure itself to the DTE rate (Bandwidth Allocation) of the rack card. Other configuration parameters remain in the default setting.
Follow the instructions below to activate NetLink Plug-and-Play between CO (Model 1095RC and CP (Model 1088) units:
•Set the Model 1095RC (CO) to either Internal or External clocking mode as defined by the application.
