4.0 INSTALLATION
Once the Model 1088/K is properly configured, it is ready to connect to the twisted pair interface, to the serial port, and to the power source. This section describes how to make these connections.
4.1 CONNECT G.703 NETWORK
The Power, G.703/G.704 and DSL Line connections are located on the rear panel of the Model 1088/K. Figure 4 shows the location of each of these ports.
Power | G.703/G.704 Terminations | DSL Line |
RXTX
Figure 4. Model 1088/K Rear Panel
4.2 JUMPER CONFIGURATION
The Model 1088/K has four jumpers (two position headers): JP1, JP4, JP5, and JP6. These jumpers are used to select input or output imped- ance matching between the module, external line, and to employ either BNC or
RX
TX
Figure 5. Top view of 1088/K, location of JP1, JP4, JP5, and JP6
14
