CENTURY SERIES

SP / TC / GT

Matrix Module

The Matrix Module allows the creation of an independent mix using the Main outputs (and an External Input) as signal sources.

Matrix AUX IN Controls

Controls level of external balanced input signals.

SIGNAL PRESENT LED

Constantly displays level activity of the matrix by varying in intensity.

100mm Fader

Used for control of all outputs of the channel. (The Insert out- put level is not affected by the fader position.)

L & R MAINS Controls

Controls level of post fader L & R signals from main section.

MONO MAINS Control

Controls the level of post fader Mono signal from main sec- tion.

STR PGM IN Control

Controls level of Stereo Program being input into the matrix. (These switches do not function on the SP/TC Consoles)

LEFT/MONO/RIGHT Switches

Selects which main section signals are introduced into the matrix. (These switches do not function on the SP/TC Consoles)

GROUPS 1-4 Controls

Adjusts the level of Group signals 1-4 introduced into the matrix.

GROUPS 5-8 Controls

Adjusts the level of Group signals 5-8 introduced into the matrix.

MUTE Switch with LED

Mutes the output. This switch does not affect the PFL switch or the Peak and Signal Present LED indicators.

TB ENABLE Control

Injects the talkback signal from the Master section into the matrix.

PFL Switch

Samples the matrix signal pre-fader and allows for monitoring within the master section of the console. This signal is not affected by the Mute Switch. When depressed, the signal level can be seen on the Left/Right meters, and heard via the mixer’s headphone or local monitor output. When this PFL Switch is depressed, the PEAK LED illuminates at a lower intensity. When used as a status indicator of switch position, the Peak LED indicating circuit remains fully operational by illuminat- ing at a much higher intensity than its use as a PFL status indi- cator.

PEAK LED Indicator

Illuminates RED when any of the points monitored come with- in 3db of the clipping point. Signal is sampled after the input preamplifier stage and after the fader.

This LED also serves as a PFL ON indicator, but at a much lower intensity than when it is used to indicate clipping.

MATRIX OUT

MTX INSERT

AUX IN 1

AUX IN 2

Rear Connections

Matrix Out

This connector delivers a balanced signal from the matrix module.

Matrix Insert

This jack allows for the insertion of an effect or signal processor into the audio path of the matrix output.

Aux In 1

This connector accepts a balanced signal at +4dB level, and then sums it with all the other signals in the matrix output.

Aux In 2

This connector accepts a balanced signal at +4dB level, and then sums it with all the other signals in the matrix output.

PAGE 21

Page 23
Image 23
Peavey GT, TC owner manual Matrix Module