Peerless Industries SA771PU manual Center Display Brackets Vertically on Back of Display

WARNING

•Tighten screws so display brackets are firmly attached to display. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

•If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly secured, damage may occur to display or product may fail.

3-3	Select the screws from the baffled fastener pack that best fit your display and secure to display following step 3-4
	or 3-5 on page 11.

NOTE: Top and bottom mounting holes must be used for attaching display brackets. Middle holes should also be used where the fasteners and displays allow.

Verify that all holes are properly aligned, then tighten screws using a phillips screwdriver.

CENTER DISPLAY BRACKETS VERTICALLY ON BACK OF DISPLAY

DISPLAY	X
B
DISPLAY BRACKETS
	X
Y	Y

NOTE: "X" dimensions should be equal. "Y" dimensions should be equal.

10 of 70 ISSUED: 10-30-09 SHEET #: 095-9299-11 03-22-12