Peerless Industries SA771PU manual Display Screw Multi Washer Bracket, Fixed Stop Position #1 with

VESA 200 x 200 or VESA 200 x 100 Mounting Pattern (Continued)

4-2	Align one display bracket with one set of display
	mounting holes.

Begin with the shortest length screw, hand thread screw through multi-washer and display brackets into display as shown. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffled fastener pack. Center display brackets vertically and tighten screws.

NOTE: For displays with a bump-out or recessed back, spacer may be used. Spacer goes between display bracket and display.

DISPLAY

SCREW

MULTI-

WASHER

DISPLAY

BRACKET

4-3	Slide universal adapter bracket to the opposite side
	and align second display bracket with second set of

display mounting holes.

Hand thread screws through multi-washer, display bracket, and spacer if used, into display as shown. Tighten all screws.

DISPLAYDISPLAY

SCREWBRACKET MULTI-WASHER

4-4	Center display brackets horizontally on back of display as shown in figure 4.3.
	Tighten two 1/4-20 x 1.25" screws. Reinstall four 1/4-20 x .6" screws using 5 mm allen wrench (I) into fixed-stop

position 1 as shown in figure 4.4.

	1/4-20 x 1.25" SCREWS
fig. 4.3	fig. 4.4	FIXED STOP POSITION #1 WITH
		1/4-20 x .6" SCREWS

13 of 70 ISSUED: 10-30-09 SHEET #: 095-9299-11 03-22-12