Adjustment of Flat Panel Display
WARNING
•M10 x 15 mm screws (E) must be securly tightened before changing orientation of wall arm assembly (A). Failure to lock adapter bracket can cause display to come off of mount.
6 | FOR PORTRAIT OR LANDSCAPE DISPLAY ORIENTATION: Remove two M5 x 12mm screws, one M5 x 6mm |
screw and rotation block from top of tilt head as shown in top view and rear view. Gently grasp sides of display and |
rotate display into portrait or landscape position as shown in figure 6.1 and reinstall rotation block with two
M5 x 12mm screws and one M5 x 6mm screw. NOTE: M5 x 6mm screw required in landscape orientation only.
ROTATION BLOCK
M5 X 6MM SCREWS
M5 X 12MM SCREWS | |
TOP VIEW | |
M5 X 6MM | M5 X 12MM |
SCREWS | SCREWS |
ROTATION |
|
BLOCK |
|
REAR VIEW
fig. 6.1 |
7 | TILT Adjustment: Adjust tension knob on side of |
mount to desired tension to enable tilt adjustment |
and balance your display size and weight. Push or pull from top or bottom of display to adjust tilt as shown. The tilt can be adjusted to a maximum of 10° forward or 5° backward. Retighten tension knob. NOTE: For larger displays, tension screw on opposite side of mount may need to be tightened using 5/32" allen wrench (P).
ROLL Adjustment: Rotate display 5° clockwise or
M5 x 10 mm roll screws using 5 mm allen wrench (I) as shown in detail 2.
FOR VERTICAL HEIGHT ADJUSTMENT: Tighten or loosen M8 x 40 mm screw to achieve ± 1" of vertical height adjustment as shown in detail 2.
CAUTION
•Do not tighten screws with excessive force.
•Be careful not to pinch fingers when opening and closing mount from the wall.
TENSION KNOB
M5 X 10 MM
SCREWS
M8 X 40 MM | DETAIL 2 |
SCREW |
15 of 70 | ISSUED: |
