6.Move the joystick up or down to toggle between On or Off.
7.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.
ALARM DWELL
(This section applies to Spectra II™ only.)
This is the minimum time the Spectra II™ will stay at an alarm even if the alarm is present for less than this amount of time.
To change the alarm dwell:
1.Program preset 95 (28 if in
2.If the cursor (>) is not beside Alarms, Zone Blank, move the joystick up or down to position the cursor beside Alarms, Zone Blank.
3.Press the Iris Open button to enter the Alarms, Zone Blank submenu.
4.Move the joystick up or down to position the cursor beside Alarm Dwell sec.
5.Press the Iris Open button. The cursor will move to the right beside the number of seconds for the alarm dwell time.
6.Move the joystick up or down and hold to cycle through
7.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.
ALARM PRIORITY
(This section applies to Spectra II™ only.)
This feature lets you set alarm inputs as either high or low priority. A high priority alarm will not release to a low priority alarm. Alarms will release or sequence between low priority alarms only if no high priority alarm exists. (Refer to the Alarms section for more informa- tion.)
To change alarm priority:
1.Program preset 95 (28 if in
2.If the cursor (>) is not beside Alarms, Zone Blank, move the joystick up or down to position the cursor beside Alarms, Zone Blank.
3.Press the Iris Open button to enter the Alarms, Zone Blank submenu.
4.Move the joystick up or down to position the cursor beside Alarm Priority.
5.Press the Iris Open button to enter the Alarm Priority submenu.
6.Move the joystick up or down to position the cursor beside the number of the alarm input for which you want to set the priority.
7.Press the Iris Open button. The cursor will move to the right beside the word High or Low.
8.Move the joystick up or down to toggle between the words High and Low.
9.SELECT - Press the Iris Open button on your keyboard to select your choice. CANCEL - Press the Iris Close button if you do not want to change the setting.
38 | Pelco Manual |
