Pelco C2406M-F (4/04) manual tamperproof screw. Refer to Figure

bottom of the base (refer to Figure 5). Pull the wiring inside the base.

WARNING: Be careful not to damage the wiring or the connection where the video cable is fastened to the circuit board.

3.Using the screwdriver bit that is provided, remove the conduit cover and plate by unscrewing the

tamperproof screw. Refer to Figure 6.

4. Install a 3/4-inch (1.91 cm) conduit connector
in the conduit opening.	Figure 5. Wiring Plug Removal

5.Line up the mounting holes in the base with the mounting holes on the mounting surface, and attach the base as follows:

If you are attaching the base to the watertight mounting plate, use the three 10-32 x 0.625-inch screws and lock washers that are provided.

If you are fastening the base directly to a wall or ceiling, use appropriate hardware (not supplied). Use 1/4-20 hex head bolts with wall anchors in high-vandalism installations.

6.Attach the base to the conduit.

7.Connect power input wires to the wires in the base of the Camclosure.

24 VAC – Connect power to the red and blue wires.

12 VDC – a. Connect +12 VDC to the blue wire and ground to the black wire.

b.Reset the voltage jumper on the camera power board. Refer to Figure 7. Remove the jumper from JP1 (AC) and reinstall the jumper on JP2 (DC).

8.Connect the video cable. Make sure the boot covers the BNC connectors.

9.Push the power wires and video cable back through the conduit fitting.

Figure 6. Base Installation with Conduit

FOUR-PIN

POWER

CONNECTOR

CONDUIT	24 VAC
COVER
	12 VDC
PLATE

Figure 7. Voltage Jumper Settings

6 C2406M-F (4/04)