Pelco C603M-A (11/07) manual Connecting To The Network, Alarm Connections

Alarm Connections

Figure 21 shows how to wire the video encoder to an alarm (refer to Table B on page 19 for the specific connector pin assignments).

Figure 21. Connecting Alarms

CONNECTING TO THE NETWORK

Connect the NET5301T-I video encoder to the Endura network:

1.Connect a Cat5e (or better) cable to the network connector on the front panel.

2.Connect the other end of the network cable to a 100BASE-T (or better) port on the Endura network switch.

NETWORK

Figure 22. Connecting the NET5301T-I to the Endura Network

After you apply power to the encoder (refer to Connecting Power on page 25), the encoder automatically searches the Endura network for other Endura components. Also, the indicators on the front panel show network connection speed and status (refer to Front Panel Indicators on page 27).

24 C603M-A (11/07)