11.Up arrow/Quit button: Used in conjunction with the Controller and ENC buttons. Press to scroll through the information on the LCD display, to move through each menu, or to go back to the previous menu.
12.Down arrow/Info button: Used in conjunction with the Controller and ENC buttons. Press to scroll through the information on the LCD display or to move through each menu.
13.
14.Exit/Alarm reset button: Use to return to the previous menu or to stop an alarm.
15.Voltage warning LED: Illuminates red and an alarm sounds if the output DC voltage is under +5 V or over +12 V.
16.Over temp LED: Illuminates red and an alarm sounds if temperature irregularities occur.
17.Fan fail LED: Illuminates red and an alarm sounds when a fanÕs rotation speed is lower than 1000 rpm.
18.Power fail LED: Illuminates red and an alarm sounds if a redundant power supply fails.
19.Power LED: Green when the power is on.
BACK VIEW
Figure 2 shows the features on the back of the IDE storage unit.
|
|
| |
|
| ||
|
|
| |
|
|
| |
POWER 1 | POWER 2 | POWER 3 | |
|
|
| UPS MODEM |
RESERVED MONITOR | |||
Figure 2. Back View
1.Host channel A: Has two
2.Host channel B: Has two
3.Terminators: Attach to Host Channel A and B Out ports.
4.Fans: Provide sufficient airflow and heat dispersion inside the storage unit.
5.Power supplies: There are three power supplies. Each one has a green LED and a power switch. The third power supply is a backup.
6.Monitor port: Serial port that allows you to connect to a PC or terminal. Factory use only.
7.Modem port: Serial port that allows you to connect to a modem. Factory use only.
8.UPS port: Allows you to connect to a UPS device. Factory use only.
9.Power fault LED: Illuminates red if there is a problem.
10.Power reset switch: Press once to reset the power fault.
11.Main power switch: Turn on after turning on the three power supplies.
7 |
