Garmin G600 Traffic Feature Options Optional, No traffic displayed, Traffic Alerts Only displayed

3.3.10.3Traffic Feature Options (Optional)

The Traffic group selection from the Map Setup Page Menu allows you to customize the display of traffic on the Navigation Map. The Traffic function requires the installation of a compatible traffic device. TIS and TAS cannot be displayed at the same time. If the aircraft has a TAS unit installed, the GDU 620 will be configured for TAS. If no TAS unit is installed and a GTX Mode-S transponder is installed then the GDU 620 will be configured for TIS. A pilot can tell which data is being displayed by the label in the top left corner (TAS OPERATING vs TIS OPERATING). TIS data comes from a GTX transponder. Coverage is limited to specific areas as shown in the Airmen’s Information Manual (AIM). TAS data comes from a TAS unit such as a Garmin GTS 800 or 820, Skywatch 497, KTA 810, or other unit. Coverage follows the aircraft. In the Navigation Map page setup you can select the maximum range at which traffic symbols are shown. Once outside of the selected range, traffic will be decluttered. The Traffic soft key will still be available.

Note: Traffic is automatically decluttered from Nav Map 1 and 2 when the map scale is above 150 NM.

Traffic Selection	Display Result
Off	No traffic displayed
All Traffic	All types of traffic displayed
TA/PA	Traffic Alerts and Proximity Alerts displayed
TA Only	Traffic Alerts Only displayed

Table 3-3 Navigation Map Traffic Display Options

Figure 3-49 Navigation Map Page Menu Traffic Group Selection

1)While viewing the Navigation Map Setup page and the Traffic Group active, turn the large MFD knob to highlight the “Traffic” options.

Foreword
System	Sec 1
PFD	Sec 2
Sec 3 MFD
Avoidance	Hazard	Sec 4
Features	Additional	Sec 5
& Alerts	Annun.	Sec 6
Symbols	Sec 7
Glossary	Sec 8
Appendix A
Index	Appendix
	B

190-00601-02 Rev. E Garmin G600 Pilot’s Guide 3-35