Garmin G600 manual Lat/Lon Viewing Range, Lat/Lon Reference Information

Lat/Lon Viewing Range

The Lat/Lon Viewing Range option selects whether Lat/Lon line is shown on the MFD. Lat/Lon lines will be shown at and below the selected map range. Map ranges above the selected value will not show the Lat/Lon lines. When Off is selected, Lat/ Lon lines will not be shown. In the figure below where 200 NM is selected, Lat/Lon lines will be shown at map ranges of 200 NM and lower.

Figure 3-39 Navigation Map Lat/Lon Selection

Lat/Lon Reference Information

Figure 3-40 Navigation Map Lat/Lon Information

1)While viewing the Navigation Map 1 or 2 of the Map page group, press the MENU key. With “Map Setup” highlighted, press ENT. With the Map Group active, turn the large MFD knob to highlight the “Lat/Lon” option.

2)Turn the small MFD knob to change the highlighted value.

3)Press ENT to accept the displayed value. The next option will be highlighted.

4)Press the small MFD knob to cancel selection or to end editing and return to the Navigation Map page or turn the large MFD knob to the next option.

Foreword
System	Sec 1
PFD	Sec 2
Sec 3 MFD
Avoidance	Hazard	Sec 4
Features	Additional	Sec 5
& Alerts	Annun.	Sec 6
Symbols	Sec 7
Glossary	Sec 8
Appendix A
Index	Appendix
	B

190-00601-02 Rev. E Garmin G600 Pilot’s Guide 3-27