Garmin G600 manual Metar Viewing Range Selection

METAR Viewing Range

The METAR Viewing Range option allows you to select the map range where at and below that value METAR weather products will be shown on the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected, METARs will not be shown. In the figure below where 150 NM is selected, METAR data will be shown at map ranges of 150 NM and lower.

Figure 4-51 METAR Viewing Range Selection

1)While viewing a WX Data Link Map page of the WX page group, press the MENU key to display the Page Menu Options. The cursor flashes on the “Weather Setup” option. Press ENT.

2)Turn the large MFD knob to highlight the METAR Data Viewing Range value.

3)Turn the small MFD knob to highlight the desired value. Press ENT to accept the displayed value. The next option will be highlighted.

4)Press the small MFD knob to cancel selection or to end editing and return to the Navigation Map page or turn the large MFD knob to the next option.

Foreword
System	Sec 1
PFD	Sec 2
Sec 3 MFD
Sec 4 Hazard Avoidance
Features	Additional	Sec 5
& Alerts	Annun.	Sec 6
Symbols	Sec 7
Glossary	Sec 8
Appendix A
Index	Appendix
	B

190-00601-02 Rev. E Garmin G600 Pilot’s Guide 4-69