Garmin G600 manual IR SAT Data Viewing Range, Gfds IR SAT Viewing Range Selection

MFD PFD System Foreword

Sec 3 Sec 2 Sec 1

IR SAT Data Viewing Range

The IR SAT Data Viewing Range option allows you to select the map range where at and below that value IR SAT weather products will be shown on the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected, IR SAT will not be shown. In the figure below where 200 NM is selected, IR SAT data will be shown at map ranges of 200 NM and lower.

Sec 4	Hazard	Avoidance
Sec 5	Additional	Features
Sec 6	Annun. & Alerts
	Sec 7 Symbols
	Sec 8 Glossary
		Appendix A
	Appendix B	Index

Figure 4-110 GFDS IR SAT Viewing Range Selection

1)While viewing a WX Data Link Map page of the WX page group, press the MENU key to display the Page Menu Options. Turn the large MFD knob to highlight the Weather Setup option and press ENT.

2)Turn the large MFD knob to highlight IR SAT Data Viewing Range. Turn the small MFD knob to highlight the desired value.

3)Turn the small MFD knob to highlight the desired value. Press ENT to accept the displayed value. The next option will be highlighted.

4)Press the small MFD knob to cancel selection or to end editing and return to the WX page or turn the large MFD knob to the next option.

4-116 Garmin G600 Pilot’s Guide 190-00601-02 Rev. E