Auto Zoom

With a valid flight plan, the Auto Zoom feature will automatically change the Navigation Map range depending on the distance to the next waypoint in the flight plan. If enabled, it will also automatically zoom to the SafeTaxi zoom range when the aircraft is on the ground. Auto Zoom can be overridden at any time by manually zooming with the RNG keys or enabling OBS mode. Auto Zoom is re- enabled once one of the following conditions is met:

1)A waypoint is sequenced,

2)the aircraft transitions from “on ground” to “in air,”

3)a point is reached where the Auto Zoom range matches the manual override range (known as auto-sync),

4)Auto Zoom is toggled off and back on in the Navigation Map Setup page,

OR

5)OBS mode is turned off.

Activating Auto Zoom

1)While viewing the Navigation Map 1 or 2 pages of the Map page group, press the MENU key.With “Map Setup” highlighted, press ENT.With the Map Group active, turn the large MFD knob to highlight the “Auto Zoom” option.

2)Turn the small MFD knob to select On or Off.

Figure 3-19 Navigation Map Auto Zoom

3)Press ENT to accept the displayed value. The next option will be highlighted.

4)Press the small MFD knob to cancel selection or to end editing and return to the Navigation Map page or turn the large MFD knob to the next option.

Foreword

 

 

System

Sec 1

 

PFD

Sec 2

 

Sec 3 MFD

 

Avoidance

Hazard

Sec 4

Features

Additional

Sec 5

& Alerts

Annun.

Sec 6

Symbols

Sec 7

 

Glossary

Sec 8

 

Appendix A

 

 

Index

Appendix

 

 

B

 

190-00601-02 Rev. E

Garmin G600 Pilot’s Guide

3-15

Page 85
Image 85
Garmin G600 manual OBS mode is turned off, Turn the small MFD knob to select On or Off, Activating Auto Zoom